If the fan won t turn on and the lights are working then there is power to the fan.
Ceiling fan remote not working light.
If you have an older ceiling fan the switch may be worn out.
If things look good return light bulbs that are in working order into their sockets.
Check whether you have a faulty connection somewhere between the switch fan and circuit breaker.
Follow the steps below to determine the cause.
Make sure the switch isn t in between positions.
The pull chain switches are in the wrong setting.
Should it become necessary to re sync the remote turn off the main power then turn it back on.
The light bulbs in the fixture are burnt out.
Flip the switch several times to make sure it is the right.
This can usually be done by checking the dip switches.
If you are using a remote or.
If the remote light up on the camera viewfinder it is working perfectly.
If no light is visible then it is busted.
The fan will turn on and light if applicable will blink three times signaling a successful synchronization.
In this case replace the reverse switch.
Check the reversing switch.
One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct.
If the ceiling fan and light works normally then the remote control module will need to be replaced.
You can do this by pointing it towards the camera of your phone and then pressing and holding a button.
Within 30 seconds use a small screwdriver to press and hold the learn button on the remote for 3 seconds.
Check whether you have loose ceiling fan wiring.
The solution is to press the fan high button and then light on on the remote control unit and then pull the pull chains until the light comes on and the fan runs on high.
Yes the ceiling fan remote control module may be faulty.
A short or an overloaded circuit can cause the breaker to trip or turn off.
They need to be set the same way on both the fan and the remote.
Screw them into.
See the links below to go to the ceiling fan area for detailed photos and instructions.
Other conditions that may prevent a ceiling fan from working.
In this case you will need to purchase a new remote and program it for the ceiling fan receiver.
Confirm the reverse switch is not in a neutral position.
The battery in the remote control needs replacing.
Check to see whether you have loose switch wiring.